Professional LED Lighting Solution for over 10 years!

Indoor Lighting/LED Down Lights/Surface Mounted Down Lights/

Ceiling Mounted Down lights

Model  CodeAlpha-SM
Product FamilyAlpha
ColourAnodised Aluminium
MaterialAnodised Aluminium
IP RatingIP54
Length (mm)62MM
Width (mm)62MM
Height (mm)135MM
Input Voltage240V
Lamp BaseGU10
ApplicationSurface Mounted
Warranty Period3Y
Warranty TypeReplacement
  • Product Detail

Ceiling Mounted Down lights from Green Lux Limited.

Ceiling Mounted Down lights ALPHA-SM is a modern, exterior ceiling-mounted direct-light exuberating quality, efficiency and performance.

Constructed from Pure 6063 Grade Aluminium and completed with a Natural Clear Anodised Finish, the ALPHA-SM is not only visually appealing, but offers greater resistance to weather exposure.

Ceiling Mounted Down lights ALPHA-SM is available with a high-performance 6W GU10 replaceable lamp (dimmable*) or without. Suitable for alfresco entertaining, BBQ areas and most other ceiling mounted exterior applications.

Ceiling surface mounted LED Down Light is a low profile downlight intended for ceiling mount applications. This luminaire offers the appearance of a recessed downlight but is actually surface mounted

Ceiling surface mounted LED downlights are characterized by a completely rotable from 0deg to 359deg and tiltle 60deg. Giving it an architecturally pleasing look. Suitable for any case you need

Deeply anti-glear design giving it you a pleasing look. Besides the color of the front ring can be black, golden or black.

How to install: 

• Please make a visual inspection to the fixture prior to installation. If any defect is to be found please return to you place of purchase for a replacement.

• Make sure all power is correctly turned off from the mains and NOT just from the switch.

• Unscrew the lamp cover from the main body. Carefully insert the supplied lamp ensuring the pins line up before securing into place.

• Ensure the silicon gasket is in place. Please do not over tighten as this may damage the gasket and inhibit correct IP protection.
• Once lamp has been installed please remove the base mounting plate. Carefully unscrew the three (3) stainless steel grub screws.
• Mount mounting base plate using supplied screws. Please note that due to different mounting sub straights additional fixing screws maybe needed (Not supplied).

• Proceed in connecting the power cable to the supplied terminal block. Due to the nature of this fixture the Earth wire MUST be connected. Please ensure the grommet supplied on the rear base plate is still present (removing this will prevent correct IP protection and void warranty)

• Once connections are made please proceed in re-attaching the main body to the mounting plate. Turn mains power back on from the mains and test to make sure all is working.

• To keep the finish maintained and in good appearance the manufacture recommends cleaning the fixture once every 12mnths with clean fresh water and a mild soap. Please rinse well.

Prev:

Next:

Leave a message